Jeep Oxygen Sensor
Because of the jobs that Jeep vehicles have to perform, remarkable performance
and longevity is really that important. And one of the factors that affect the
utility of your Jeep vehicle is its oxygen sensor.
Jeep oxygen sensor is the device that significantly measures the amount of oxygen
in the exhaust, converts its status into a corresponding voltage signal and sends
this voltage signal into a computer in the vehicle. The computer will then issue
a command to the fuel injector to adjust and maintain the proper air/fuel ratio.
Jeep oxygen sensor needs to check this red-hot exhaust hundreds of times per minute
to make sure that it gets a correct data which will be forwarded to a computer
in the vehicle.
Oxygen sensors come in few types including front or upstream oxygen sensor and
rear or downstream oxygen sensor. Positioned in the exhaust manifold or in the
downpipe before the catalytic converter, the front or upstream oxygen sensor checks
the quantity of oxygen in the exhaust gases and gives “feedback” signal to the
computer in the engine. The rear or downstream oxygen sensor is the one that’s
placed after the catalytic converter and it is responsible for monitoring the
efficiency of the automobile’s catalytic converter.
Having such a critical job, your Jeep oxygen sensor needs to be taken-cared of
and maintained properly. As they become older, Jeep oxygen sensors can turn out
to be inaccurate, leading to waste of fuel and some engine performance problems.
So if you notice that your Jeep oxygen sensor is poorly operating, better replace
it immediately to avoid further damage as well as fuel inefficiency.
And to avoid constant replacement of your Jeep oxygen sensor, make sure to check
it when you conduct a routine vehicle tune-up. Remember that checking your Jeep
oxygen sensor is as important as changing your vehicle’s oil, checking the spark
plugs and replacing the air filter. |
